:: View topic - How to connect to the EN5861 via HTTP

xDSL Discussions - How to connect to the EN5861 via HTTP

martin_legionowo - Sep 21, 2007 - 12:13 PM
Post subject: How to connect to the EN5861 via HTTP

Hello,
I cannot connect to the EN5861 via HTTP, telnet.
I have EN5861 P/N - 060-5861-F36. Modem comes
from Britain - could be BT modem.
Modem has IP - 192.168.254.254 but I cannot
connect via telnet and HTTP - it looks like
it doesn't have open these services - it answer
only for ping. I set 192.168.254.1 IP address for a laptop because also DHCP on modem has disabled.
I don't have console cable.
Is it any tricks to connect to this modem without
console cable in this scenario ?

Any helps would be appreciated !
Best Regards,
Marcin

eusty - Sep 22, 2007 - 12:53 AM
Post subject: RE: How to connect to the EN5861 via HTTP

Netboot the router then you should be able to connect to it, then you can remove the BT 'locking'

system snmpport default
system telnetport default
system deltelnetFilter 194.72.0.0 194.72.32.255
system deltelnetFilter 194.74.75.0 194.74.75.255
del autoexec.old
remote del bt
save
sync
reboot

martin_legionowo - Sep 25, 2007 - 12:32 PM
Post subject: RE: How to connect to the EN5861 via HTTP

Hello,
thanks for help but during the POST phase - it looks like modem
doesn't want boot via BOOTP protocol - it doesn't send BOOTP
request always boots from flash only. May you tell me if we
can we change the sequence - the first via BOOTP secend from flash ?
Best Regards,
Marcin

TheBoy - Sep 29, 2007 - 08:49 PM
Post subject: RE: How to connect to the EN5861 via HTTP

Try this:
http://forum.lettronics.com/forums/thread/49.aspx

though you will have to download all stuff from this website rather than feldtest

martin_legionowo - Oct 02, 2007 - 09:38 AM
Post subject: RE: How to connect to the EN5861 via HTTP

Hi,
thanks for link to the page with information how do it,
but in my opinion there is a mistake :
copy tftp@192.168.254.254:asic.aic asic.aic (only for 5861)
should be :
copy tftp@192.168.254.100:asic.aic asic.aic
Obviously when we have TFTP server on 192.168.254.200 machine.
Am I right ?
Best Regards,
Marcin

TheBoy - Oct 02, 2007 - 06:33 PM
Post subject: RE: How to connect to the EN5861 via HTTP

Yes, typo. Sorry

martin_legionowo - Oct 07, 2007 - 02:25 AM
Post subject: Thanks for help

Hi,
finally I did it, everything is ok, I had to upgrade firware via Configuration Manager. When I upgrade via TFTP then always it boot from net not from the flash. After upgrade via Configuration Manager it boots from the the flash properly.
So, thanks TheBoy and eusty for your help !
Best Regards,
Marcin